If you want to ensure that your Titan PowrLiner remains your asset for years, then you must know that maintenance should go beyond just a simple water rinse. It does not matter if you’re operating a 3500 or an 8905 heavy-duty sprayer; the longevity of any machine thoroughly depends on protecting the fluid section and the pump from corrosion and paint build-up.
Below, we are going to guide you on how you can maintain your line striper for peak performance. Let’s get into the details and help you understand everything.
The Critical Post-Job Flush
One of the first things that you have to pay attention to is that you must not let the paint sit in the system. Even paints that have low viscosity can skin and clog the internal valves of the piston pump. You should flush the system with mineral spirits or water until you see that the discharge is completely clear.
You must also not forget to flush the spray valve and the gun filter. If the manifold filter is clogged, it can cause wiggly lines and pressure drop.
Lubrication and “Throat Seal Liquid” (TSL)
The piston rod is known to be the heart of the PowrLiner sprayer. If it is not properly lubricated, the packing will completely dry out, and the friction will score the piston rod, and you will have to spend your money on getting expensive repairs. What you have to do is add a few drops of Titan seal liquid into the cup before you use it.
This liquid will prevent the paint from drying on the piston rod, which acts as a seal against the packing if it is left untreated.
Storage Protection
If you’re not going to use your machine for a really long time, like for more than 24 hours, the air and moisture can completely get trapped inside the pump and it can start to cause corrosion. It can also cause frozen valves. After you have flushed the system, you need to circulate the liquid shield through the system.
The major benefit of doing this is that this specialized additive will prevent rust, and it will keep the internal valves from sticking. This will ensure the machine primes immediately the next time you take it to the job site.
Hardware and Tire Maintenance
If you have been using a line striper for a long time, you must know that they are subject to constant vibrations, which can contribute to loosening the components that keep the lines straight. What you have to do is periodically check the alignment to see if the front wheel is centered perfectly. If there is even the slightest drift it will ruin the long line project.
You must also ensure that the tires are inflated according to the manufacturer’s specifications. If the tire pressure is low, it will make the carriage tilt which will result in uneven line edges. You should also inspect the spray trigger cable. If there is a lot of slack at stop and start points on the line, it will be messy, and you will not get sharp and crisp lines.
Maintenance Checklist For Titan PowrLiner 850 Parts
There is a proper maintenance checklist that we are going to mention below so you can keep a check on each part of your sprayer accordingly.
The piston wet cup, filters, and the spray tips should be checked after every single use. You should add 5 to 10 drops of TSL to the piston wet cup after usage. You should clean the filters thoroughly and inspect for any sort of mesh tears. You must also clean the spray tips with a soft brush and store them in a tip guard solution to get the best performance.
You should check the inlet screen weekly. What you can do is check for dried paint that can be restricting the flow. Lastly, you should change the engine oil after every 50 hours because that is how you’re going to get a top-notch performance from your sprayer. See more.
Bottom Line
If you think it is enough to purchase a top-notch machine, and then you will not have to spend your time on it then you’re definitely wrong. You have to thoroughly maintain your sprayer to make sure you get straight lines from it when you’re working.
We have mentioned the maintenance checklist above that you should follow to keep your sprayer in the best condition and to get accuracy and precision from it. With that being said, if you want to get your hands on Titan PowrLiner 850 Parts, then connect with us at AllTitanParts.